MadgeTech QuadTemp Data Logger - Manual (Page 3)

QuadTemp and OctTemp
Product Operation
1.
Insert the Software USB Stick in an open USB port. If the autorun does not appear,
locate the drive on the computer and double click on Autorun.exe. Follow the instructions
provided in the Wizard. Install the MadgeTech 4 Software and USB Drivers onto a
Windows PC.
2.
Launch the MadgeTech 4 Software.
3.
The IFC200 interface comes with a USB cable. Plug one end of the cable into an avail-
able USB port on the PC and plug the opposite end of the cable into the communication
port on the IFC200. The drivers will install automatically.
4.
The device will appear in the Connected Devices list, highlight the desired data logger.
For most applications, select “Custom Start” from the menu bar and choose the desired
start method, reading rate and other parameters appropriate for the data logging applica-
tion and click “Start”. (“
Quick Start” applies the most recent custom start options, “Batch
Start” is used for managing multiple loggers at once, “Real Time Start” stores the dataset as
it records while connected to the logger.) The status of the device will change to “Running”,
“Waiting to Start” or “Waiting to Manual Start”, depending upon your start method.
5.
Disconnect the data logger from the interface cable and place it in the environment to
measure. Note: The device will stop recording data when the end of memory is reached or
the device is stopped. At this point the device cannot be restarted until it has been
re-armed by the computer.
6.
To download data, connect the logger to the interface cable. Highlight the data log-
ger in the Connected Devices list. Click “Stop” on the menu bar. Once the data logger is
stopped, with the logger highlighted, click “Download”. You will be prompted to name
your report. Downloading will offload and save all the recorded data to the PC.
Quick Start Steps
1