JJC RM-E4 - Manual

1
JJC RM-E4
Infrared Remote Control Instruction
Thank you for purchasing JJC RME4 Infrared Remote Control. For the best performance, please read this
instruction carefully before use.
z To use RM-E4 Remote Control
1. For the first time use, please pull out the plastic separator (if your remote control has it) at the battery
holder.
2. Mount the camera on a tripod (recommended) or place the camera on a stable, level surface.
3. Press the button and rotate main command dial until (delayed remote) or (quick response remote) is
displayed in the control panel.
4. Aim the transmitter on the remote control at the infrared receiver on the camera (usually within +/- 20
degree of the lens axis, from the left to the right and from the top to the bottom) and press the shutter-release
button on the remote control (when using the remote outdoors, make sure that the subject is not backlit and
that the line of site between the transmitter and the infrared receiver is not blocked by the lens or other
obstacles).
5. How the camera focuses and shoots depends on the option selected for your camera's custom setting. For
further information, check your camera's manual.
Infrared cannot be seen by human eyes. So you will see no visible light from the LED on the front end of the
remote control when operating.