Aiwa AV-D77 - Manual (Page 14)

13
ENGLISH
RADIO RECEPTION
MANUAL TUNING
1 Turn the FUNCTION to select the TUNER function,
and press the DIGITAL/ANALOG/BAND button
repeatedly to select the desired band.
The display changes to frequency indications after indicating
band and video source (V1, V2 or V3) for two seconds.
2 Press the
N
or
M
button to select a station.
Each time the button is pressed, the frequency changes.
When a station is received, “TUNE” is displayed for two
seconds. During FM stereo reception,
1 is displayed.
NOTE
To tune in to a station with the remote control, preset the
stations first (see the next page). You can select the desired band
with the TUNER/BAND button and tune in to the preset stations
by pressing the UP or DOWN button.
To search for a station quickly (Auto Search)
Keep the N or M button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the
N or M button.
• The Auto Search may not stop at stations with very weak
signals.
When an FM stereo broadcast contains noise
Press the MONO TUNER button on the remote control so that
“MONO” appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, press the button so that “STEREO”
appears.
When the reception contains noise interference
Move the unit away from other electrical appliances, especially
digital audio devices, or turn off the appliances that generate
noise signals.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation
system is 9 kHz/step, change the tuning interval.
Hold down the DIGITAL/ANALOG/BAND button and press the
POWER button.
To reset the interval, repeat this procedure.