Ouellet OWS - Manual (Page 24)

24
Electrical connection
• Perform insulation and resistance tests before connecting the system to the controller and enter results in the
measurement table.
• Follow the controller manufacturer’s instructions for connecting the heating cable system. Instructions are part
of your product packaging. You may also look up instructions on our Internet site at www.ouellet.com.
Note: If you need assistance with the connection of the OWS-T heating cable system, please contact Ouellet Canada’s
specialists at 1 800 463-7043.
6
Electrical connection should be performed by a master electrician.
System connection should be performed once the heating cable is
completely embedded and the curing period for coatings is complete.
Follow the manufacturer’s recommendations.
This product must be installed with a ground fault circuit interrupter
(GFCI) in compliance with the Canadian Electrical Code
(CSA C22.1 Section 10) and the National Electrical Code.
CAUTION!
CAUTION!
CAUTION!