Prochem ProCaps Deluxe - Manual (Page 19)

19
Maintenance
Machine Troubleshooting
PROBLEM CAUSE SOLUTION
No power to machine
Tripped electrical circuit
breaker in fuse box of building
Check building circuit breaker
Faulty power cord Replace power cord
Power switch failure or relay
failure
Replace power switch or relay
Tripped circuit breaker
Reset circuit breaker. Higher amp draw may
indicate faulty parts. Find parts not moving
freely and correct as needed.
Internal wiring problem
With machine unplugged, check for and correct,
any loose wire connections.
Faulty rectifier Replace rectifier
Electrical Shock
Equipment not grounding Follow grounding instructions, pg 2-3
Receptacle not grounded Have an electrician inspect the building's wiring
Internal electrical problem
Check for any loose wire connections, replace
any items that are short circuiting
Nuisance tripping of circuit
breaker
Faulty circuit breaker Replace circuit breaker
Mechanical problem
Test circuit breaker for continuity. Higher amp
draw may indicate faulty parts. Find parts not
moving freely and repair or replace.
Brush not turning or scrubbing
Faulty brush motor/gear box Replace brush motor/gear box
Belt failure Replace belts
Worn brush motor brushes Replace brushes, check commutator
Power to motor but motor
does not run
Worn brush motor brushes Replace brushes, check commutator
Bearing squealing or grinding
in brush housing
Worn bearings Replace worn bearing
Machine will only run if the
green (on) switch is continu-
ously held down
Defective red (off) switch.
Sends constant "off" signal.
Replace or reconnect wire to red (off) switch
No flow or uneven flow from
jet (Deluxe only)
Clogged jet Clean or replace jet
Weak flow from clean jet
(Deluxe only)
Clogged strainer Clean strainer
Pump runs but no flow from jet
(Deluxe only) Disconnect coupling at
solution tank
Attach the quick coupling to the solution tank
86269870 CARPET MAINTAINER