ProMariner ProIsoCharge - Manual (Page 3)

Warning
Before connecting to batteries read all instructions and cautionary markings
on the battery charger and batteries. Do not discard this manual, save it for
future reference.
1. SAVE THESE INSTRUCTIONS - This manual contains important safety, operating and installation
instructions for the ProIsoCharge Series. Do not discard this manual, save it for future reference.
2. Do not expose to rain or snow.
3. Use of attachments not recommended or sold by Professional Mariner, LLC will void warranty
and may result in a risk of fire, electrical shock or personal injury.
4. Do not operate the charger if it has received a sharp blow, direct hit of force, been dropped
or otherwise damaged in any way.
5. Do not disassemble the battery charger. If service or repair is required please contact customer service
at 1-800-824-0524. Incorrect reassembly may result in a risk of electric shock or fire.
6. To reduce the risk of electrical shock, remove 120 volt or 240 volt AC shore power. Also remove DC
battery connections prior to any maintenance or cleaning. Turning off controls will not reduce this risk.
WARNING AVOID SERIOUS INJURY OR DEATH FROM FIRE, EXPLOSION OR ELECTRICAL SHOCK
- Make connection in an open atmosphere free of explosive fumes.
- Make connection in a secure manner that will avoid contact with water.
WARNING – RISK OF EXPLOSIVE GASES.
a) WORKING IN THE VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS. BATTERIES
GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON,
IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING YOUR CHARGER, YOU
READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY.
b) To reduce risk of battery explosion, follow these instructions and those published by battery
manufacturer and manufacturer of any equipment you intend to use in vicinity of a battery(s).
Review cautionary markings on these products.
PERSONAL PRECAUTIONS
a) Someone should be within the range of your voice or close enough to come to your aid
when working near a Lead-acid battery.
b) Have plenty of soap and water nearby in case battery acid comes in contact with skin,
clothes or eyes.
c) Wear complete eye protection and clothing protection. Avoid touching eyes while working
near battery(s).
d) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid
enters eye, immediately flood eye with running cold water for at least 10 minutes and get
medical attention immediately.
e) NEVER smoke or allow a spark or flame in the vicinity of a battery or engine.
Incorrect assembly may result in electrical shock or fire.
4 3
Warning
DO NOT attempt to install or operate the unit if it has been damaged in any way.
IMPORTANT NOTICE – PLEASE READ AND UNDERSTAND THIS MANUAL BEFORE
INSTALLING YOUR PROISOCHARGE SERIES.
This manual is written to assist in the installation of your new ProIsoCharge; however, since
this is a permanent DC hardwired installation, ProMariner strongly recommends that a Certified
Marine Electrical Technician
® trained by the American Boat and Yacht Council (ABYC) perform
the installation. The ProIsoCharge unit you have purchased was constructed to the safety
standards of the ABYC to prevent fire and electrocution; the installation must conform to
these same industry standards. For more information on ABYC, their Standards and Technical
Information reports for Small Craft and to find a certified technician near you, visit www.abyc.com.
CAUTION: To preclude a safety hazard, all existing DC electrical components (e.g. wire,
fuses, circuit breakers, battery switches, and connections) must be inspected for proper
condition prior to installation. Failure to confirm adequate condition and proper installation
to ABYC standard E-11 AC & DC electrical systems on board boats may result in a dangerous
condition and/or premature failure of this or other installed electrical components. Any and
all areas of the existing system that are found not in compliance with ABYC E-11 must be
replaced prior to installation.
CAUTION: If you are replacing an existing battery charger please disconnect the battery
charger output cables from the existing charger AND the battery(s). Do not use existing cables
if they are not in compliance with the sizes detailed in this manual. If you have any doubt
about your ability to fuse and wire this unit correctly PLEASE refer to www.abyc.com for a
list of certified electricians in your area that are qualified to perform this installation to the
ABYC standards.
Designed, Constructed and Tested to:
WARNING / AVERTISSEMENT :
DO NOT EXPOSE TO RAIN OR SPRAY / NE PAS EXPOSER AUX INTEMPÉRIES
WARNING: LOW VOLTAGE / ATTENTION : BASSE TENSION
ELECTRICAL BURN AND SPARK HAZARD. BEFORE OPENING DISCONNECT CHARGER CONNECTIONS AT BATTERY(S).
(DANGER DE BRULURES ELECTRIQUE ET ETINCELLES). AVANT D'OUVRIR LA BOITE DECONNECTER LES
CONNECTIONS ENTRE CHARGEUR ET BATTERIE.
CAUTION:
- HOT SURFACES - TO REDUCE THE RISK OF BURNS, DO NOT TOUCH.
- RISK OF ELECTRIC SHOCK. NO USER SERVICEABLE PARTS. RETURN TO MANUFACTURER FOR SERVICING
- THIS CHARGER IS MEANT FOR CONTINUOUS DUTY
- IGNITION PROTECTED
- FOR MARINE USE
ATTENTION :
- SURFACES CHAUDE-NE PAS TOUCHER, RISQUES DE BRULURES
- RISQUE DE CHOCS ELECTRIQUE-RETOURNER AU FABRIQUANT POUR SERVICE.
- CE CHARGEUR EST FABRIQUE POUR LE DEVOIR CONTINU
- PROTÉGÉ CONTRE L’EXPLOSION
- POUR UTILIZATION MARINE