ROTRONIC CF8-W-Disp-GH User Manual
Page 3
Dokument
IMA 211
Rev
1
Page
3 (4)
Note 1: The ground terminal is used as negative power supply DC input or AC
phase ground G0 (halfwave rectifier).
Note 2:
CF8-W-Disp-GH can deliver a voltage or a current loop for OUT1 and OUT2.
To change between voltage and current output mode the hardware jumpers are
used. There is one jumper for OUT1 and one for OUT2, so that one output can be a
voltage output and the other a current output. Both, voltage output and current
output, can have start points 0 % (0-10 VDC or 0-20mA) or 20% (2-10 VDC or 4-
20mA). The same start point is used for both outputs. See the function manual.
If for some reason the PCB must be removed it must be handed carefully
and protected from electrostatic discharge! Normally, removing the PCB is
not required.
Never feed more than one cable through each cable entry bushing.
The lid can be locked with the screw at the bottom of the sensor box.