ROTRONIC HF62 - Manual (Page 5)

E-M-HF62-V1_11
Rotronic AG
Bassersdorf, Switzerland
Document code Unit
Instruction Manual
Document Type
HygroFlex HF62 Humidity Temperature
Transmitters: User Guide
Document title
Page 5 of 27
© 2008; Rotronic AG E-M-HF62-V1_11
1 2 3 4 5 6 7 8 Optional keypad and display
D Keypad and display (no backlight)
X No keypad and display
Probe length options (except wall mount configuration)
S Standard length
1 Standard length + 150 mm
2 Standard length + 300 mm
3 Standard length + 450 mm
4 Standard length +600 mm
Cable fittings
1 1x M16 cable grip
3 1x ½” conduit adapter
Standard dew / frost point output ranges
X X No calculated parameter
B X -50…50 (°C / °F - as per temperature output range)
C X -50…100 (°C / °F - as per temperature output range)
D X -50…200 (°C / °F - as per temperature output range)
S C Custom range. Specify when ordering
Notes
:
o
Output 1: relative humidity or dew point
o
Output 2: temperature
o
The enclosure of all HF62 models is designed to be installed in the horizontal position
o
Cable grips are located at the bottom of the enclosure
o
Conduit adapters are located on top of the enclosure
o
The dew / frost point range uses the same unit (˚C or ˚F) as the temperature output. The factory default
setting is frost point below freezing.
o
Custom range: be sure to clearly specify the desired range at the time of the order. When a special range
has been ordered, the letters ST and SC are used in columns 4 and 7 in the above table. These generic
codes will be replaced with a specific code only for quantity and repeat orders