Setra System Model 567 - Manual (Page 3)

Please Note : The Series 567 is designed and manufactured in accordance with sound engineering
practice as defined by the Pressure Equipment Directive 97/23/EC. This product must not be used as a
“safety accessory” as defined by the Pressure Equipment Directive, Article 1, Paragraph 2.1.3. The CE
Mark on the unit does not relate to the Pressure Equipment Directive.
INTRODUCTION
Series 567 are fluid pressure measuring transducers in which a four active arm Wheatstone bridge of thin
film CVD gauges, integral with a beam structure connected to a pressure summing diaphragm, is used to
convert fluid pressures into a proportional electrical signal.
Common integral electronics converts the input from the gauge to a 4-20mA 2-wire output signal.
Series 567 conform with the essential protection requirements of the EMC Directive 89/336/EEC
amended by certified type testing to EN 50082-2 and EN 60081-1.
Conformity with the requirements of the CE mark only applies when the installation
conditions described in these instructions have been met. For units supplied without
a cable assembly connection to the transmitter must be accomplished using Setra
Systems approved cable. see APPROVED CABLE section.
All instruments conform to the appropriate specifications and/or drawings applicable and have been
subjected to relevant strict quality control procedures.
HAZARDOUS PRODUCTS
The Consumer Protection Act of 1987, Section 6 of the Heath and Safety at Work Act 1974 and the
Control of Substances Hazardous to Health Regulations 1988 require that we advise recipients and
users of our products of any potential hazards associated with their storage, handling or use.
The products which our Company supplies may be classified as Electrical, Electro-Mechanical and
Electronic equipment.
These products are tested and supplied in accordance with our published specifications or individual
special requirements that are agreed in writing at time of order. They are constructed so as not to affect
adversely the safety of persons and property when properly installed, maintained and used by qualified
personnel, in the applications for which they were designed and manufactured
ACTION ON RECEIPT
* Check details on Calibration Certificate agree with data etched on transmitter body.
* Check accessories supplied include:
Calibration Certificate (or QA Certificate)
Seal, Dowty Bonded (where applicable)
Mating Connector (where applicable)