Setra System Model 567 User Manual
Page 8
SERVICING
The transducer cannot be repaired locally and if damaged should be returned to Setra Systems with the
following:
1.
Name and phone number of person to contact
2.
Shipping and billing information
3.
Full description of malfunction
4.
Remove any pressure fittings and plumbing that you may have installed and enclose any required
mating electrical connectors and wiring diagrams.
Please ship prepaid to Setra Systems at the address shown below or to your local Setra Distributor
when a replacement/repair is required:
United States
Outside The United States
Setra Systems Inc
Contact your local Setra Distributor
159 Swanson Road
Boxborough. MA 01719
Attn: Repair Department
RETURN TO FACTORY
PLEASE NOTE: To comply with Health and Safety requirements, the instrument must be clean and
safe to handle and accompanied by a formal statement to that effect duly signed by an authorised officer
of the Company.
Any instrument returned without certification will be quarantined and no action will occur until cleared. It
may ultimately be returned to you and subject to a transportation charge.
ELECTRICAL CONNECTION
W
IRING
E
LECTRICAL
C
ONNECTION
(+)
(-)
Earth
E2
DIN
1
2
4
B3
10-6 bayonet
A
B
E
UA
IP68 Cable
R
BL
Drain
159 Swanson Road, Boxborough, MA 01719-1304
Tel: 800-257-3872 / 978-263-1400
OP567 Rev A 11/03