Aiwa XR-M150 - Manual (Page 12)

11
ENGLISH
BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
1
a
4
2
s
MODE
3
Preparation
• Use Type I (normal) tapes only.
• Set the tape to the point where recording will start.
1 Insert the tape to be recorded on into deck.
Insert the tape with the side to be recorded on first facing out
from the unit and the exposed side down.
2 Press TAPE/REV MODE to select the reverse
mode.
To record on one side only, select p .
To record on both sides, select [ or ] .
When using the remote control, press MODE.
3 Press function (TUNER, AUX/VIDEO or CD) and
prepare the source to be recorded.
To record from a CD, press CD and load the disc.
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
To record from a connected source, press AUX/VIDEO and
play.
4 Press w REC/REC MUTE to start recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press s .
To pause recording, press a (applicable when the source is
TUNER or AUX/VIDEO). To resume recording, press it again.
To erase a recording
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing TAPE/REV MODE.
4 Press AUX/VIDEO and turn the connected equipment off.
5 Press
w REC/REC MUTE to start the erasure.
RECORDING
Sound adjustment during recording
The output volume and tone of the speakers or headphones may
be freely varied without affecting the recording.
INSERTING BLANK SPACE
Insertion of 4-second blank spaces may help you to locate the
beginning of the track on other equipments. This unit can add
blank spaces only when the source is TUNER or AUX/VIDEO.
1 Press
w REC/REC MUTE during recording or while in
recording pause mode.
4 on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press a to resume recording.
To insert a blank space of less than 4 seconds, press
w REC/REC MUTE again while 4 is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters the recording pause mode, press
w REC/REC MUTE
again.
Each time
w REC/REC MUTE is pressed, a 4-second blank
space is added.
*This unit does not have the function to locate the beginning of track.
Recording cannot be done when TAPE function is selected.
09-14/XR-M150<U>/Eng 10/4/2000, 5:09 PM 11