Aiwa XR-M150 - Manual (Page 16)

15
ENGLISH
SETTING THE TIMER
VOL/
MULTI JOG
6
1, 2, 3, 4
2, 3, 4
3
1
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly. (See page 14).
1 Press TIMER once to display “ 5 ”, then press
ENTER within 6 seconds.
“ 5 ” is displayed and the time flashes.
If you press ENTER after 6 seconds, another operation may
start.
2 Designate the timer-on time by pressing f or
g , then press ENTER.
To change the timer-on time by 30 minutes, press and hold
f or g .
• VOL/MULTI JOG is also available instead of f and g .
After you designate the timer-on time, one of the source names
flashes on the display.
3 Press any of the function buttons (TAPE, TUNER,
AUX, CD) or press f or g to select a source,
then press ENTER.
The duration for the timer activated period flashes.
• If TUNER is pressed, the band cannot be selected in this
step.
• VOL/MULTI JOG is also available instead of f and g .
After you select a source, the duration for the timer-activated
period flashes on the display.
4 Select the duration for the timer-activated period
with f or g , then press ENTER.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
• VOL/MULTI JOG is also available instead of
f and g .
5 Prepare the source.
To listen to a CD, load the disc.
To listen to a tape, insert the tape into deck.
To listen to the radio, tune in to a station.
To listen to the equipment connected to AUX/VIDEO jacks,
set the timer of the connected source (with an external timer)
and prepare for the play.
6 Press POWER to turn the unit off after adjusting
the volume and tone.
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power is
turned off with the volume level set to 21 or more.
To check the specified time and source
Press TIMER. The timer-on time, the selected source name and
the duration for the timer-activated period flash alternately for 6
seconds.
To cancel timer standby mode temporarily
Press TIMER repeatedly until “ 5 ” or “ ” disappears on the
display.
To restore the timer standby mode, press TIMER once or twice
to display “
5 ” or “ ”.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
• Timer playback and timer recording will not begin unless the
power is turned off.
• Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and AUX/VIDEO (with
an external timer) sources only.
Press TIMER repeatedly until “ ” appears on the display,
then press ENTER within 6 seconds.
Carry out the steps of “SETTING THE TIMER” from step 2 and
insert the tape to be recorded on into deck after step 5.
15-18/XR-M150<U>/Eng 10/4/2000, 5:08 PM 15