Sterlco 140 to 6,285 Gallon Pump Tanks - Manual (Page 10)

Pump Tanks Chapter 3: Installation 10 of 36
Chapter 3: Installation
3-1 Uncrating Your Pump Tank
Caution! Due to the size and weight of larger model pump tanks, the manufacturer
recommends using bonded professional millwrights to unload and move larger
pump tanks.
Rig the pump tank from the frame only and use spreader bars to prevent load transfer to any
pump tank components. Rig the frame from at least four points and balance the load before
lifting to clear the skid.
3-2 Installation Location Considerations
Consider the following points when locating your pump tank:
• Locate close to the chillers and/or cooling towers and the process itself to minimize
field piping expense
• Locate adjacent to drain and city water sources
• Consult a structural engineer to assure that the floor, mounting pad, or structural steel
support is of adequate strength
3-3 Rigging
Due to the large size and weight of the pump tanks, we recommend professional rigging and
installation. We have a nationwide installation organization that can install your system.
Do not remove the base skid until the unit is at the final location. Lower the unit (do not drop
it) from any truck, platform, or shipping dock.
All 150 through 400 Series pump tanks are provided with lifting lugs on the pump tank
frame. All 500 Series and larger tanks are provided with lifting lug brackets on the pump tank
body. When lifting, use adequately rated hoist, lifting straps and/or chains. Avoid transferring
the load to the pumps and any other components.
Metal pump tanks are provided with slots in the frame for use with fork trucks of sufficient
capacity and properly sized forks.