Timeguard TG77 - Manual (Page 9)

8
Press → to set minutes to 10
Press SET, display shows:
Press → to set seconds to 30
Press SET, display shows:
Now press CTD to start the countdown procedure. Output light will
turn ON and the appliance plugged into the TG77 will be energised
while the display counts down to zero when the appliance will be
turned OFF. Before pressing CTD ensure the TG77 is plugged into a
live socket and the appliance is switched ON. If the CTD button is not
pressed within 10 seconds of the previous use of the SET button the
display will revert to normal operation mode. To retrieve the setting
press ← and then SET after which countdown can be started by
pressing the CTD button.
11. Operating the TG77 in Timed
ON/OFF Mode
Ensure that the unit is in operating mode. Press the button until
the left side of the display shows AUTO and either ON or OFF as
appropriate for the programme(s) at that time of day and day of
week. Then plug the TG77 into a live socket, plug the appliance to be
controlled into the TG77 and ensure the appliance is switched ON.
The TG77 will enact all programmes stored on a continuous basis.
To override the unit at any time press the button twice. The
display will change from AUTO OFF to AUTO ON or from AUTO ON
to AUTO OFF and the override will last until the next programme
change.
To go to a continuous ON or continuous OFF condition press the
button repeatedly until either ON or OFF as appropriate is on the
display without the AUTO symbol.