Commissioning, Diagnostics – Timeguard EADS User Manual
Page 12
11
5. Commissioning
Switch on the mains supply to the Control Unit and check the
left hand ‘Supply On’ indicator (green) is illuminated. The ‘Fault’
(yellow) and ‘Alarm’ (blue) indicators should be off.
If the Fault indicator is illuminated this almost certainly
indicates that there is an open or short circuit in the extra low
voltage wiring. Assuming the Fault indicator is off pull the pull
cord and the system should behave as described in the second
paragraph of section 2.
Having observed this to be the case press the Reset button on
the Control Unit to end the alarm. Pull the pull cord again and
verify each unit is performing correctly then press the Reset
button on the Reset Unit to end the alarm.
6. Diagnostics
Warning : Switch off mains supply before removing
the front cover or dismantling the control unit.
Remove all power source including battery when
wiring any part of the system.
The following possible faults and solutions are for guidelines
only. If in doubt contact the Timeguard Helpline on
020 8450 0515