UEi Test Instruments AQM4 - Manual (Page 14)

P30 TEMPERATURE UNIT
When P30 and "UNIT" (Fig 25) are displayed
on the LCD, press to go into P31 to
choose the temperature unit.
The set value will display on LCD (Fig 26)
Press or to choose C° or F° and
press to confirm.
-OR- Press to escape and return to
P30.
P40: LOGGING SAMPLING RATE
P40 allows you to set sampling rate of data
logging (Fig. 27). The range is from 1 second
to 4 hours 59 minutes and 59 seconds.
Press to display current setting and
enter edit mode. The display is in the
format [HH. MM. SS.] The hour digits will
be flashing. To change intervals between
logged readings, press to increase and
to decrease. Press again to
confirm and enter minute setting. Press
to confirm and enter seconds setting.
(Fig 28) Press to confirm the rate
setting.
-OR- Press to escape and return to
P40.
13