Hotpoint Ariston AVTL 104 - Manual (Page 7)

7
GB
Function Effect Comments Enabled with
programmes:
Super
Wash
Allows for an
impeccable
wash, visibly
whiter than a
standard
Class A wash.
This function is incompatible with the RAPID function.
1, 2, 3, 4,
5, 6, 7, 8
Easy iron This option
reduces the
amount of
creasing on
fabrics,
making them
easier to iron.
When this function is set, programmes 6, 7, 8, 11 and
Delicate rinse will end with the laundry left to soak
(Anti-crease) and the Rinse cycle phase LED will
flash.
- to conclude the cycle, press the START/RESET
button;
- to run the draining cycle alone, set the knob to the
relative symbol and press the START/RESET
button.
All
programmes
except for
1, 2, 9, 10
and
Draining.
Rapid Cuts the
duration of
the wash
cycle by 30%.
This function is incompatible with the SUPER WASH
function.
1, 2, 3, 4,
5, 6, 7, 8
Rinses
Extra
Rinse
Increases the
efficiency of
the rinse.
Recommended when the appliance has a full load or
with large quantities of detergent.
1, 2, 3, 4, 5,
6, 7, 8, and
Rinse
cycles.
Personalisations
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to a cold wash ( ).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cottone 1000 rpm
Synthetics 800 rpm
Wool 600 rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol .
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum speed for
each programme.
 To avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner by
continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed than
the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.