Aiwa CSD-FD82 - Manual (Page 4)

4
ENGLISH
Power supply
The OPE/BATT indicator lights up while the power is
on.
Using on AC house current
Connect the AC cord as illustrated below.
• The rated voltage of the unit is 120 V AC.
• If abnormal high voltage is supplied, “Hi” flashes in
the display and the unit does not accept any
operation. Disconnect the AC cord.
CAUTION
Use only the supplied AC cord. Use with other cords
may result in the risk of fire.
Demo display
When connecting the unit to an AC outlet for the first
time, the demo display will begin automatically. The
illuminations on the front panel also flash (CSD-FD92
only).
To turn off the demo, press * DISPLAY/COLOR/DEMO.
You can turn it on or off by pressing DISPLAY/COLOR/
DEMO while the power is off.
* or DISPLAY on the remote control
• When using the unit on the batteries, the demo is not
displayed.
• For ordinary use, turn off the demo to save power
consumption.
Using on batteries
Open the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, as
illustrated below. Then close the lid.
To switch from AC power supply to battery supply,
disconnect the AC cord from the AC inlet.
When the OPE/BATT indicator becomes dim, volume
decreases, or sound is distorted during operation,
replace the batteries.
When the batteries become weak during tape
operation,
“Lo” flashes in the display and the unit will
be stopped or turned off. Replace the batteries.
Notes on batteries
To avoid damage from leakage or explosion, observe
the following:
• Insert the batteries with the 0 and 9 marks correctly
aligned.
• Do not mix different types of batteries or old batteries
with new ones.
• When the unit is not to be used for a long period,
remove the batteries.
• Never recharge the batteries, apply heat to them or
take them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
Changing the display color
You can select the color of the display light:
orange, blue, purple (or turned off).
Press * DISPLAY/COLOR/DEMO repeatedly while
the power is on.
* or DISPLAY on the remote control
• When using the unit on the batteries, the display
light is off.
Illuminations on the front panel (CSD-FD92
only)
The illuminations light up or flash while the power is
on. In playback mode, they will show the
approximate sound level.
To turn off the illuminations, hold down * DISPLAY/
COLOR/DEMO while the power is on. To resume,
hold it down again.
* or DISPLAY on the remote control
• When using the unit on the batteries, the
illuminations are off.
R14 (C)
supplied AC cord
1 to the AC inlet of
the unit
2 to an AC outlet
(AC 120 V, 60 Hz)
OPE / BATT