Remote retrieval, Setting a remote access code, Using your remote access code – Brother MFC-L8600CDW User Manual

Page 42

Advertising
background image

Chapter 4

36

Remote retrieval

4

You can call your machine from any touch-
tone telephone or fax machine and then use
the remote access code and remote
commands to retrieve fax messages.

Setting a Remote Access
Code

4

The Remote Access Code lets you access
the remote retrieval features when you are
away from your machine. Before you can use
the remote access and retrieval features, you
must set up your own code. The factory
default code is the inactive code (– – –l).

a

Press .

b

Press All Settings.

c

Swipe up or down, or press a or b to
display Fax.

d

Press Fax.

e

Swipe up or down, or press a or b to
display Remote Access.

f

Press Remote Access.

g

Enter a three-digit code using the
numbers 0 to 9, * or # using the

Touchscreen's keyboard.
Press OK.

(The preset ‘l’ cannot be changed.)

NOTE

DO NOT use the same code used for your
Fax Receive Code (l51) or Telephone
Answer Code (#51) (see
Basic User's Guide).

h

Press .

NOTE

You can change your code at any time. To
make your code inactive, press and hold

at step g to restore the inactive

setting – – –l, and then press OK.

Using your Remote Access
Code

4

a

Dial your fax number from a telephone
or another fax machine using touch
tone.

b

When your machine answers,
immediately enter your Remote Access
Code (3 digits followed by l).

c

The machine signals if it has received
messages:

1 long beep -- Fax messages

No beeps -- No messages

d

When the machine gives two short
beeps, enter a command (see Remote
fax commands
on page 37
). The
machine will hang up if you wait longer
than 30 seconds to enter a command.
The machine will beep three times if you
enter an invalid command.

e

Press 9 0 to reset the machine when you
are finished.

f

Hang up.

NOTE

• If your machine is set to Manual mode

and you want to use the remote retrieval
features, wait for about 100 seconds after
it starts ringing, and then enter the remote
access code within 30 seconds.

• This setting may not be available in some

countries or supported by your local
telephone company.

Advertising
This manual is related to the following products: