Brother MFC-J4710DW - Manual (Page 29)

Configuring your machine for a wireless network
23
3
Configuring your machine when the SSID is not broadcast
3
(For MFC-J2510/J4510DW/J4710DW)
3
a Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
Check and record the current wireless network settings.
1 TKIP is supported for WPA-PSK only.
NOTE
If your access point/router uses WEP encryption, enter the key used as the first WEP key. Your Brother
machine supports the use of the first WEP key only.
b Press .
c
Press All Settings.
d
Press Network.
e Press WLAN.
f Press Setup Wizard.
g When Switch Network interface to wireless? is displayed, press Yes to accept.
This will start the wireless setup wizard.
To cancel, press No.
SSID (Network Name):
Communication Mode Authentication method Encryption mode Network key
Infrastructure Open system WEP
NONE
—
Shared key WEP
WPA/WPA2-PSK AES
TKIP
1
For example:
SSID (Network Name):
HELLO
Communication Mode Authentication method Encryption mode Network key
Infrastructure WPA2-PSK AES 12345678