Brother PT-H500 - Manual (Page 59)

TROUBLESHOOTING
58 Error Messages
Memory Full! There is not enough internal memory available when you try to save
a label file. Delete any unnecessary files to make more memory
available for the new label file.
Check # of Digits
Entered! The number of digits entered in the bar code data does not match the
number of digits set in the bar code parameters. Enter the correct
number of digits.
Input A,B,C or D At
Start&End! The bar code data entered does not have the required start/stop
code (A, B, C, or D required at the beginning and end of the bar code
data for the CODABAR protocol). Enter the bar code data correctly.
Maximum Of 5 Bar
Codes Per Label!
There are already 5 bar codes entered in the text data when you try
to enter a new bar code. You can only use up to five bar codes in
each label.
Text Too Large! The text size is too large. Select a different size option.
Select Other Cut
Option! The tape length set using the tape length setting is shorter than the
total length of the left and right margins applied for the "Large
Margin" cut option. Select a different cut option.
Close Cover! The rear cover is open. Close the cover when printing.
Installed tape is not
compatible with this
machine!
Tape that is incompatible with the P-touch labeler has been installed.
Use a compatible tape.
Category Full! The memory available for categories is full. To make more memory
available, delete any unnecessary registered label files by
highlighting the label file and pressing the OK key.
Already Exists in
Favorites! The label which already exists is added in favorites category of label
collection.
Favorite Folder
Empty!
Favorites folder of label collection is empty.
Insert Corresponding
Tape Cassette! Either no tape cassette is installed, or a 0.47" (9 mm) width or
narrower tape cassette is installed when printing from the label
collection.
If a Heat Shrink Tube is installed, you are trying to print a label that
cannot be printed on Heat Shrink Tube.
Install an appropriate tape.
System Error 01! Please contact our customer service.
Refer to the Quick Setup Guide for the contact information.
System Error 02! Please contact our customer service.
Refer to the Quick Setup Guide for the contact information.
Message Cause/Remedy