Brother MFC-J4410DW - Manual (Page 193)

Remote Setup & PhotoCapture Center™
185
11
c
Launch any FTP software or any web browser in which FTP is supported.
Your browser software accesses the memory card or USB Flash memory drive using the FTP protocol
and the network Host Name of the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where
XXX.XXX.XXX.XXX is the IP address of your Brother machine).
Your browser software appears and a list of file names on your memory card or USB Flash memory drive
is shown.
d
Click the name of the file you want to see.
NOTE
Using certain characters or symbols in a file name on the memory card or USB Flash memory drive may
cause a problem accessing the file. We recommend to only use combinations of the following characters
in a file name.
When you take out a memory card or USB Flash memory drive, do the following to prevent damage
to the memory card or USB Flash memory drive:
11
a
Close the browser.
b
Wait until the LCD message disappears before taking out the memory card or USB Flash memory drive.
IMPORTANT
DO NOT remove the memory card or USB Flash memory drive while the LCD is displaying a message.
Otherwise, the card, USB Flash memory drive or data stored on the card could be damaged.
If you remove the memory card or USB Flash memory drive while the LCD is displaying the message, you
must restart your computer once before inserting the same memory card or USB Flash memory drive into
the machine. If you do not restart your computer, the data on your media could be destroyed.