Brother PE-DESIGN Ver.6 - Manual (Page 105)

Advanced Opreation
Design Center
97
Design Center
Stage 4 (Sew Setting Stage)
Moving the center point of the
concentric circle stitch and radial stitch
In order to increase the decorative effect, you can
move the center point of regions set to the
concentric circle stitch or radial stitch.
1. Click on the Tool Box.
→ The shape of the pointer changes to
.
2. Select the desired color and sew type
(Concentric Circle Stitch or Radial Stitch).
3.
Click the region.
→ The center point ( ) appears.
4.
Drag the center point to the desired location.
b
Memo:
To move the center point later, click ,
and then click the region with the concentric
circle stitch or radial stitch applied. The
center point appears and can be moved.
Specifying hole sewing
By specifying hole sewing, the stitching in
overlapping regions will not be sewn twice. Hole
sewing can be set only when one region completely
encloses another.
1. Click on the Tool Box.
→ The shape of the pointer changes to
.
2. Click the region that completely encloses
another region.
→ A Set hole sewing dialog box similar to
the one shown below appears.
b
Memo:
To cancel hole sewing, click the white inner
region. The inner region will be sewn twice
when it appears in the same color as the
outer region.
3. Click OK to set hole sewing.
b
Memo:
To quit applying hole sewing, click Cancel.
PeDesignV6Eng.book Page 97 Thursday, July 8, 2004 11:59 AM