Brother HL-8050N - Manual (Page 112)

11 - 1 TROUBLESHOOTING
11
11
Troubleshooting
Overview
This chapter describes procedures for troubleshooting problems you
may encounter with a Brother print server, it is divided into the
following sections:
1 Installation Problems
2 Intermittent Problems
3 Protocol-Specific Troubleshooting
Installation Problems
If you cannot print over the network, check the following:
1 Make sure that the printer is powered on, is on-line and ready to
print.
Verify that the printer and the configuration are good by printing
the printer settings page. Refer to the Quick Setup Guide. If the
test fails, check:
a If the LED is not blinking after connected to the network, then
the network firmware settings may be corrupted. Please refer
to Step 3.
b In this event, try to restore the factory default settings of the
print server. To reset the print server, turn off the printer and
then turn it on while holding down the + button. Keep the
button pressed down until the LCD display shows
READY . You
can check the settings by printing the printer settings page.