Brother DCP-J152W - Manual (Page 19)

19
For Wireless Network Users
Wirele
ss Network
12 Manual setup from the
control panel using the
Setup Wizard
(Windows
®
,
Macintosh and mobile devices)
a
If you began the wireless setup from step 7 on
page 7, press a or b to choose Setup Wizard
and press OK. Then go to
c.
All other users go to b.
b
On your machine, press Menu.
Press a or b to choose Network. Press OK.
Press a or b to choose WLAN. Press OK.
Press a or b to choose Setup Wizard. Press
OK.
c
When Enable WLAN? is displayed, press OK
to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
d
The machine will search for available SSIDs. It
will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is displayed, press a or b to
choose the SSID you wrote down in step
11-b
on page 16. Press OK.
If the wireless access point/router of the
selected SSID supports WPS, and the machine
asks to use WPS, go to
e.
If the machine asks you to enter a Network
Key, go to
f.
Otherwise, go to g.
e
Press + (Yes) to connect your machine using
WPS. (If you choose - (No) to continue manual
configuration, go to
f to enter a Network Key.)
When the LCD shows Start WPS, press the
WPS button on your wireless access
point/router, and then press + (Next) to
proceed. Go to
g.
f
Enter the Network Key you wrote down in
step
11-b on page 16. Press a, b, d or c to
select a letter or number, and then press OK.
When you have entered all of the characters,
press a, b, d or c to select and then press
OK. Then press + (Yes) to apply your settings.
g
Your machine will now try to connect to your
wireless network. It may take a few minutes.
When appears on the LCD, press OK.
Wireless setup is now complete.
You must have the wireless settings you
wrote down for your network in step
11-b on
page 16 before you proceed.
NOTE
• If the list is blank, check that the wireless
access point/router has power and is
broadcasting the SSID. Move your machine
closer to the wireless access point/router and
try starting from
a again.
• If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For more information, see Configure
Your Wireless Network When the SSID Is Not
Broadcast in the Software and Network User’s
Guide.
NOTE
Press a, b, d or c to select , and then press
OK to cycle between upper case, lower case and
special characters. To move the cursor left or
right, press a, b, d or c to select
or , and
then press OK.
(For more information, see Entering Text for
Wireless Settings on page 30.)
NOTE
If the connection failed, check the error code on
the printed report and refer to Troubleshooting
on page 22.
OK OK
OK OK