Accel TEMPEST 3302 - Manual (Page 15)

15
INSTALLATION
10
Connect the two hoses together using the "Y" connector (left hand
subject arrow). Connect the Tempest
® Spray line to the press spray
hopper line using the reducer (right hand subject arrow).
Attach the exhaust fan/manifold assembly to the center of the
delivery guard as shown. Make sure that the arrow on the fan is
pointing toward the guard (out of the press) and that the wires are
routed toward the NOPS of the press. The top two screws go
through the second slot down from the top of the guard. Make sure
that the open end of the manifold is pointing toward the NOPS. You
will need to file the openings in the guard so that the screws will
pass through the guard.
11
12
Locate the 2 impression cylinder activation solenoids located on
the OPS of the press, one under each head. Remove the 2 outside
nuts and screws from each solenoid (lower subject arrows). Install
the provided longer M4 x 16MM screws. Install the supplied switch
assemblies (as shown in the picture) over the screws and secure
them using the original hardware.
The left photo show the #1 head solenoid and the right shows the
#2 head solenoid. Note how the microswitch trip arms extend up to
the spring studs located on activation linkage (upper subject
arrows).