Accel TEMPEST 3302 - Manual (Page 7)

7
1
2
3
INSTALLATION
Cut the sprayer hose about halfway between the hopper and the
spray bar. A new hose will be attached to the spray mechanism.
Remove the spray bar by removing the two bolts holding the
bracket (subject arrow). Also remove the clip holding the spray
hose (subject arrow, picture on following page).
DISCONNECT THE POWER TO THE PRESS BEFORE
BEGINNING INSTALLATION.
Remove the two large side covers over the main framework of the
press (one at OPS and one at NOPS) and the NOPS cover at the
delivery end of the press.
For an easier installation, you may also want to remove the two
guards on the delivery end of the press.
NOTE: Do not cut the hose if the press is equipped with an
Airtech sprayer.
NOTE: Do not remove the spray bar if the press is equipped
with an Airtech sprayer.