Audiovox DKP102 - Manual (Page 13)

System Panel Controls
11
DKP102 Operation
SETTING THE CLOCK:
NOTE: All settings are preformed in standby mode.
1.Selecting 12 or 24 hour display mode:
a.) Press the “clock mode” button once. The 12H/24H and AM/PM indicator will flash.
b.) Press the “radio tune/clock set” ( - ) or (+) button to toggle between 12 or 24 hour modes.
2. Setting the time:
a.) Press the “clock mode” button twice. The hours and minutes will flash.
b.) Press the “radio tune/clock set”( - ) button to set the hour . This will also set AM/PM.
c.) Press the “radio tune/clock set”(+) button to set the minutes.
3. Selecting the alarm type:
a.) Press the “clock mode” button three times. The alarm indicator will flash.
b.) Press the “radio tune/clock set” (
-
) or (+) button to toggle between the three alarm options
(Alarm/Radio and OFF). A musical note will appear to indicate the radio has been selected.
A bell will appear to indicate the alarm tone has been selected. If the alarm OFF mode is
selected there will be no indicator displayed
4. Setting the alarm time:
a.) Press the “clock mode” button four times. The alarm indicator will be displayed and the hours
and minutes will flash.
b.) Press the “radio tune/clock set” (
-
) button to set the hour
.
This will also set AM/PM.
c.) Press the “radio tune/clock set” (+) button to set the minutes.
d.) Press the clock set button to turn off the alarm.
5.Recording a voice message
a.) Press the “REC” button until " REC " appears on the display.
b.) You can record a personal message up to 2 minutes long.
c.) When the message is complete press the “REC” button again to stop recording.
d.) The message indicator will flash to indicate a message is waiting.
e.) Press the “REC” button to delete the recorded message.
6.Playback of the voice message
a.) Press the “PLAY” button until " PLAY " appear on the display.
b.) Press the “PLAY” button again to stop playback of the message.
7.Timer countdown
- Maximum countdown time of 24 hours is allowed.
- Press the “TIMER” button to set the timer countdown.
- Press the “clock set” button to set the timer (-) for hours (+) for minutes.
- Press the “Timer” button to start the count down.
- Press the “Timer” button again to stop the count down.
- A buzzer will sound when the count down timer is completed
- Press the “Timer” button stop the buzzer.
Note: If the DKP102 is on and the alarm is set to the radio source the alarm will not sound. When the
alarm is set to the buzzer source, the buzzer will sound at the same time as the program audio.