Audiovox DKP102 - Manual (Page 5)

Connections & Setup
Mounting Instructions
Before Mounting
Empty contents from the selected counter which the unit will be mounted.
Clean the underside of the counter.
We recommend the unit be mounted to the front edge of the counter.
Mounting Procedure (Refer Figure 1)
3
1) Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an
electrical outlet and a TV antenna or cable connection will facilitate a neat, easy installation.
Do not mount the DKP102 above a range or oven. Be sure that the location chosen will
provide adequate access to the electrical connection on the rear of the unit before
continuing.
2) If the location chosen has bottom edge molding it may be necessary to use the mounting spacers
provided to effectively lower the DKP102 below or even with the molding. Measure the distance
between the bottom and the bottom of the cabinet. For large molding choose a combination
of spacers which will allow the DKP102 to be secured to the bottom of the cabinet.
3) Measure the thickness of the bottom of the cabinet or shelf and the spacers chosen. Select
the shortest screw length which will secure the DKP102 to the bottom of the cabinet.
4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center
punch the four holes indicated on the template and remove the template.
5 ) Carefully drill four 1/8” (5MM)holes at the locations marked above. Place the screws selected through
the DKP102 and then through the spacers(if required from the bottom-up).
6) Position the DKP102 and screw it in place using the selected screws. Do not over tighten.
7) Connect your TV antenna or cable system to the antenna connector on the rear of the DKP102.
8) Plug the AC adaptor into the rear of the DKP102 and then into the wall.
9) Attach the supplied AM/FM antenna to the AM/FM antenna jacks on the rear of the DKP102.
10) Route the wires safely away from heat and moisture sources and secure them in place using
the self adhesive wire mounting clip provided.