Canon REALIS WUX10 MARK II D - Manual (Page 38)

Connecting the Projector
38
BNC cable (Input signal type: [ANALOG PC-2] - P49 )
■Connecting to DVI Monitor Output Terminal (digital connection)
DVI cable (Input signal type: [DIGITAL PC] - P49 )
• It cannot project a signal whose dot clock is 170MHz or higher.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
turns down the sound.
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
turns down the sound.
Monitor output
terminal
(mini D-sub 15-pin)
Audio output terminal
(AUDIO OUT)
To input a corresponding audio signal:
Commercial audio cable
Commercial BNC cable
To AUDIO IN
To ANALOG PC-2/
COMPONENT IN
Computer Projector
mini D-sub 15-pin – BNC
Terminal Convert Cable
(commercial item) mini D-sub 15-pin – BNC
Terminal Convert Cable
(commercial item)
Monitor output
terminal
(DVI terminal)
Audio output terminal
(AUDIO OUT)
DVI digital cable (LV-CA29, option)
To input a corresponding
audio signal:
Commercial audio cable
To ANALOG PC-1/
DVI-I IN
To AUDIO IN
Computer Projector