Canon REALIS WUX10 MARK II D - Manual (Page 97)

97
Setting Various Function
Setting Up Functions fr
om
Menu
s
Prohibiting the Projector Operation
[Key lock]
You can prohibit the operation of the projector
from either the top control or remote control.
Press the OK button to accept your setting
and then press the MENU button.
• [Off] is the factory default.
Setting up the Remote Control Channel
[Remote control]
You can set different channels to different
remote controls, if you use two projectors
at the same time.
Press the OK button to accept your setting
and then press the MENU button.
• The factory defaults is [Ch1] for both
projector and remote control.
• After changing the channel on the
menu, be sure to change the channel of
the remote control, too.
Selecting a Channel on the Remote Control
You can change the channel on the
remote control as follows:
HDMI COMPONENT
DIGITAL PC VIDEO
ANALOG PC
Off Disables the key lock.
Main unit Prohibit the operation from the
main unit.
Use the remote control.
Remote
control Prohibit the operation from the
remote control.
Use the main unit.
The key lock function becomes effective
from the moment the OK button is
pressed after selecting [Main unit] or
[Remote control]. Be sure to press the
OK button on the top control or remote
control which is not locked.
Key lock
System settings
To Unlock Key Lock Function
Turn off the projector and unplug the power
plug. Hold down the OK button on the top
control and connect the power plug. Make
sure to keep holding down the OK button
until a beep sounds. The key lock is
unlocked.
HDMI COMPONENT
DIGITAL PC VIDEO
ANALOG PC
Ch1 Select the channel of the remote control
used for this projector, and press the OK
button.
Ch2
Ch1 Press the OK button and [ ] for 3 sec-
onds at the same time.
Ch2 Press the OK button and [>] for 3 sec-
onds at the same time.
Remote control
System settings
<