Canon imagePROGRAF iPF815 MFP M40 - Manual (Page 9)

9
Troubleshooting
Phenomenon Cause Corrective Action
The Printhead is out of alignment. Adjust the Printhead alignment.
Make sure the same type of paper is specified in the
printer driver as you have loaded in the printer.
(→ , If Vertical Lines are Warped or Colors are
Misaligned)
The Printhead nozzles are
clogged. Print a test pattern to check the nozzles and see if
they are clogged.
(→"Checking for Nozzle Clogging," User Manual)
Streaks may occur if you set the
Print Quality too low. Choose a higher level of Print Quality in the
Advanced Settings of the printer driver and try
printing again.
Printing in Draft or Standard mode is faster and
consumes less ink than in Highest or High modes,
but the printing quality is lower.
The type of paper specified in the
printer driver does not match the
type loaded in the printer. Load paper of the same type as you have specified in
the printer driver.
(→
, Loading Rolls in the Printer)
(→ , Loading Sheets in the Printer)
Hold down the Stop button for a second or more to
cancel printing. 1.
Change the type of paper in the printer driver and
try printing again. 2.
Banding in different colors occurs The paper feed amount is out of
adjustment. Adjust the feed amount.
(→"Adjusting the Feed Amount," User Manual)
Printing does not proceed
smoothly because print jobs are
interrupted during transmission. Exit other applications and cancel other print jobs.
In the printer menu, Print Length
is specified in Feed Priority . Selecting Band Joint may improve printing results.
Adjust the feed amount in the printer menu by
specifying Band Joint in Feed Priority and try
printing again.
(→"Adjusting the Feed Amount," User Manual)
(→"Giving Priority to Particular Graphic Elements and
Colors for Printing," User Manual)