Canon EOS-1D C - Manual (Page 28)

Automatic Image Transfer After Each Shot
28
5
Select the size and type of images
to transfer.
To transfer smaller JPEGs when the camera is set up to record
larger JPEGs to one card and smaller JPEGs to the other, set [JPEG
size to trans.] to [Smaller JPEG].
To transfer either RAW or JPEG images when the camera is set up
to record RAW images to one card and JPEGs to the other, specify
which images to transfer in the [RAW+JPEG transfer] setting.
Similarly, complete the same setting when RAW+JPEG images are
recorded simultaneously to a single memory card.
When images of the same size are recorded to both cards
simultaneously, images recorded to card 1 are transferred,
regardless of image quality (compression).
If transfer fails, the <Y> lamp on the
camera blinks in red. In this case, press
the <7> button, select
[Communication settings] on the [53]
tab, and press <0>. When the screen
shown on the left is displayed, check the
error number and see page 84 to eliminate the cause of the error.
Once the cause of the error is eliminated, the images whose transfer
previously failed will be transferred automatically. With this option
activated, transfer is attempted again automatically after failure, both
when automatic transfer is used and when transferring captured images
via FTP. Note that when you cancel image transfer, or turn off the
camera, the image will not be re-transferred automatically. See page 34
and transfer the image manually.
Auto Retry if Transfer Fails
COP
Y