Canon imagePROGRAF iPF765 MFP M40 - Manual (Page 462)

Paper cutting (to have the roll cut at your specified position)
1
Press the Feed button.
2
Press the ▼ button to advance the roll to the position for cut-
ting.
3
Press the Cut button.
4
Press ▲ or ▼ to select Yes, and then press the OK button.
After the roll paper is cut, it is rewound automatically.
Caution
• If paper would be short when cut at a particular position, the roll may automatically be advanced in some cases
before cutting.
Cutting the Leading Edge of Roll Paper Automatically Cutting the Leading Edge of Roll Paper Automatically
If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, set
Trim Edge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut the leading edge
to make the edge straight after you load a roll.
Trim Edge First offers the following options.
Cutting the Leading Edge of Roll Paper Automatically iPF765
User's Guide
Handling Paper
Handling rolls
462