Insufficient paper for job, This paper cannot be used as size is not supported – Canon imagePROGRAF iPF8400 User Manual

Page 995

Advertising

Cause

Corrective Action

If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to Rolls.")

→

P.536

Because the Platen is soiled with ink or other substances, the size of the clear film cannot
be detected.

Open the Top Cover and clean the entire Plat-
en.
(See "Cleaning Inside the Top Cover.")

→

P.943

Insufficient paper for job

Cause

Corrective Action

The printer has received a print job longer than the amount of roll paper left when Man-
ageRemainRoll in the Control Panel menu is On.

Press ▲ or ▼ to select Print, and then press the OK
button to resume printing.
When using the Media Take-up Unit, press ▲ or ▼
to select Print, and then press the OK button to re-
sume printing.
However, the roll paper may run out during the print
job and you may not be able to print all of the docu-
ment.

Press ▲ or ▼ to select Change Paper, and then
press the OK button.
Change the Paper Source of the printer driver, or re-
place the roll with a roll that has enough paper for
the print job, and then printt.
When using the Media Take-up Unit, press ▲ or ▼
to select Stop Printing, and then press the OK but-
ton to stop printing.
Remove the printed document from the Media Take-
up Unit, replace the roll with a roll that has enough
paper for the print job, and then try printing again.
(See "Removing the Roll from the Printer.")