Canon imagePROGRAF iPF8400 - Manual (Page 999)

Cannot feed paper. Cannot feed paper.
Cause Corrective Action
Paper could not be
advanced correctly
during feeding. 1. Lift the Release Lever and remove the jammed paper.
(See "Clearing Jammed Roll Paper.")
→ P.958
(See "Clearing a Jammed Sheet.") → P.961
2. Load paper.
3. Lower the Release Lever.
4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.") → P.539
(See "Loading Sheets in the Printer.") → P.561
Cannot cut this paper. Cannot cut this paper.
Cause Corrective Action
There are sheets left on the Ejec-
tion Guide. 1. Lift the Release Lever and remove the paper.
2. Load paper.
3. Lower the Release Lever.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Rolls in the Printer.") → P.539
There is a foreign object by the
Output Tray, obstructing the Cut-
ter Unit. 1. Lift the Top Cover and remove the foreign object.
2.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the
OK button.
Printing will resume, starting from the page on which the error occurred.
You are not using the printer un-
der the recommended environ-
mental conditions for the paper. Use the printer only where the recommended environmental conditions for the paper are met. Note that
various environmental conditions are recommended for various types of paper. For details on the recom-
mended environmental conditions, see the Paper Reference Guide.
(See "Paper Reference Guide.")
You are using paper that is not
compatible with automatic cut-
ting. 1.
Specify Manual as the cutting method and use scissors or a cutting tool to cut the roll.
(See "Specifying the Cutting Method for Rolls.")
→ P.552
For information about paper that is compatible with automatic cutting, see the Paper Reference Guide.
(See "Paper Reference Guide.")
2. Lift the Release Lever and remove the paper.
In other cases, the Cutter Unit
may be damaged. Contact your Canon dealer for assistance.
End of paper feed. End of paper feed.
Cause Corrective Action
Although an attempt was made to advance the paper manually, it reached the limit position
that can be advanced. Canceling manual advancing.
(See "Feeding Roll Paper Manually.")
→ P.549
Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit. Canceling manual advancing.
Rel lever is in wrong position. Rel lever is in wrong position.
Cause Corrective Action
The Release Lever is up. Lower the Release Lever.
iPF8400 Cannot feed paper.
User's Guide
Error Message
Messages regarding paper
999