Apex Digital GB4308 - Manual (Page 35)

33
Projection - GB4308, GB5108
Programming the Remote Control
Remote-control switchover
Press VCR/DVD, SAT/CABLE or AUX to select the device you want to control.
To program the remote control
Press and hold VCR.DVD, SAT/CABLE or AUX for over 2 seconds until the LED on the remote control turns
off. Release the button the LED will light again (the remote control enters the PROGRAMMING mode).
Enter three-digit code number for your equipment. If the correct code number is entered, the LED blinks
three times. If you enter a code not listed below, or you press any other buttons than SEARCH and 100+,
the LED turns off.
To search codes
Press ad hold VCR/DVD,SAT/CABLE or AUX for over 2 seconds unil the LED turns off. Release the button
(the LED wil light again) and the remote control enters the PROGRAMMING mode.
Press SEARCH.
Press CH+/- to search codes downwards or upwards. Each time you press CH+/-, the code number decreas-
es or increases by 1 while the remote control sends the code number for POWER button on your device.
If the desired code number is found,press 100+ to program the code for your device until the LED blinks
three times.Then the remote control exits from the PROGRAMMING mode and returns to norml operation.
Or press any other button to exit from the PROGRAMMING mode after the LED blinks rapidly eight times,
and the operation is not active.
To check the current code number
Press and hold VCR/DVD, SAT/CABLE or AUX for over 2 seconds until the LED turns off. Release the but-
ton (the LED will light again) and the remote control enters the PROGRAMMING mode.
Press 100+ .
You may read the code numder according to the LED display status as follows.
* If there is no operation within 20 seconds during the steps mentioned above, the remote control will
automatically exit from the appropriate operation.
Code Number
First - digit
0
1
0
1
Second - digit
0
0
4
5
Third - digit
0
6
3
0
First - digit
Blinks rapidly once
Blinks once
Blinks rapidly once
Bliks once
Secod - digit
Blinks rapidly once
Blinks rapidly once
Blinks four times
Bliks five times
Third - digit
Blinks rapidly once
Blinks six times
Blinks three times
Bliks rapidly once
LED Display Status
(2 sec. time interval between every two digits.)
Other Information