Installation instructions – Electrolux EIFLS60JIW User Manual
Page 11
11
Installation Instructions
If your washer has this console:
If your washer has this console:
Empty washer’s drum and close door.
1.
After you plug in the washer the fi rst time: wake up the washer by pressing any button, rotate cycle knob to cycle
2.
one up from lower right position (1), press the start button (3) and then the cancel button (4).
Wake up the washer again by pressing any button, then immediately and simultaneously press and hold buttons
3.
2a and 2b for 5 seconds, or until the LCD display changes.
The LCD window will display
4.
INSTAL CYCLE and show estimated time of cycle completion. Press the start
button (3). The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the
LCD window may display
INSTAL PASS!, meaning your new washer is properly installed and ready for use. If it
prompts an action such as
NO WATER, CHECK HOSES or CALL SERVICE 877 435 3287, review the
installation steps and make the necessary corrections before you attempt to use the washer.
Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.
5.
After you plug in the washer the fi rst time: wake up the washer by pressing any button and then follow the
1.
prompts on the LCD User Interface, including language selection.
The Installation Cycle will automatically perform various diagnostic routines. At cycle completion, the LCD window
2.
may display
INSTAL PASS!, meaning your new washer is properly installed and ready for use. If it prompts an
action such as
NO WATER, CHECK HOSES or
CALL SERVICE 877 435 3287, review the installation steps and make the necessary corrections before
you attempt to use the washer.
Your washer will exit the Installation Cycle and return to normal operation the next time you wake it up.
3.
Please read the
6.
Use & Care Guide and enjoy your new premium washer!
Please read the
4.
Use & Care Guide and enjoy your new premium washer!
Performing Installation Cycle
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately
run the washer through a washing cycle, press the cancel button to put the unit to sleep
and then rewake it immediately to continue the normal operating mode.
NOTE
Washer will stay awake for 3 minutes after the Installation Cycle. If you wish to immediately
run the washer through a washing cycle, press the cancel button to put the unit to sleep
and then rewake it immediately to continue the normal operating mode.
1
2a
2b
3
4
With your washer in fi nal location, perform an Installation Cycle to assist in proper installation.