Installation requirements, Clearance requirements, Important – Electrolux EIFLS60JIW User Manual

Page 5: Installation in a recess or closet

Advertising
background image

5

MINIMUM INSTALLATION CLEARANCES - Inches (cm)

SIDES

REAR

TOP

FRONT

Alcove

0” (0 cm)

0” (0 cm)*

0” (0 cm)

n/a

Under-
Counter

0” (0 cm)

0” (0 cm)*

0” (0 cm)

n/a

Closet

0” (0 cm)

0” (0 cm)*

0” (0 cm)

1” (2.54 cm)

Installation Requirements

Clearance requirements

0”

(0cm)

0”

(0cm)

1”

(2.54cm)

0”

(0cm)

IMPORTANT

DO NOT INSTALL YOUR WASHER:
1. In an area exposed to dripping water or out-

side weather conditions. The ambient temper-
ature should never be below 60° F (15.6° C) to
maximize detergent effectiveness.

2. In an area (garage or garage-type building)

where gasoline or other fl ammables (including
automobiles) are kept or stored.

3. On carpet. Floor MUST be solid with a maxi-

mum slope of 1 inch (2.54 cm). To minimize
vibration or movement, reinforcement of the
fl oor may be necessary.

INSTALLATION IN A RECESS OR CLOSET

If washer and dryer are installed in the same
closet, door ventilation is required: A minimum of
120 square inches (774.2 cm²) of opening, equally
divided at the top and bottom of the door, is
required. Louvered openings should be located 3
inches (7.6 cm) from bottom and top of door. Air
openings are required to be unobstructed when a
door is installed. A louvered door with equivalent
air openings for the full length of the door is
acceptable.

60 sq. in.

(387.1cm²)

3”

(7.6cm)

60 sq. in.

(387.1cm²)

3”

(7.6cm)

closet door

Advertising