Cleaning and care – Electrolux EI30SM35QS User Manual
Page 37
E
ORM 2.0 Bottom [TINSEB310WRRZ] [13 13
ORM 2.0 Bottom [TINSEB310WRRZ] [13 13
10/19/10 1:21:38 PM
10/19/10 1:21:38 PM
NOTE:
smoke and odors.
1.
2. To remove grease filters, slide each filter to
3.
detergent. Scrub and swish to remove
embedded dirt and grease. Rinse well and
shake to dry. Do not clean filters with
ammonia, corrosive cleaning agents, such
4. To replace grease filters, slide filter in the
frame slot on one side of the opening.
Push filter upward and push to the other
side to lock into place.
5. Plug in microwave oven or reconnect power.
1. Unplug microwave oven or disconnect power.
2. Open the microwave door and remove the two
3. Slide the vent left and tip forward. Lift out to
remove.
Unplug microwave oven or disconnect power.
as lye-based oven cleaners, or place them
in a dishwasher. The filters will turn black or
become damaged.
vent mounting screws located on top of the microwave
using a
#
#
1
#
Phillips screwdriver.
#
NOTE:
Do not operate the hood without the
The charcoal filter
Models are shipped for recirculating exhaust (To duct air outside reference the Installation Instructions
book included with your microwave.). Some models have a disposable charcoal filter installed to help remove
5.
should rest like the picture shown below.
6. Reinstall the vent by sliding the bottom of the
vent into place. Push the vent top into position
7. Close the microwave door. Plug in microwave
mounting
oven or reconnect power.
1
#
Phillips screwdriver.
and slide right into place. Replace the two vent
screws located on top of the microwave
4.
filter straight out.
using a
CLEANING AND CARE
to the other side the filter will drop out.
the side. Pull filters downward and push
Soak grease filters in hot water and a mild
grease filters in place.
The grease filters should be removed and cleaned often; at least once a month.
Lift the bottom of the charcoal filter. Slide the
Slide a new charcoal filter into place. The filter
Grease filters
Charcoal filters
Caring for the Filters
37
cannot be cleaned and should be replaced every 6 to 12 months.