Electrolux EXM24HV1WE - Manual (Page 6)

6
installation site instruction
More than 30cm
More than 30cm
More than 2m
More than 50cm
More than 15cm (ceiling)
More than
15cm
More than
15cm
More than 2m (floor)
Less than 2.5m (floor)
7 Select place about 1m or more away from a
TV set or any other electric appliance.
8 Select a place where the filter can be easily
taken out.
9 Do not use the unit in the laundry or by
swimming pool etc.
10 A minimum pipe run of 3 meters is required to
minimize vibration and noise.
11 Use a stud finder to locate studs to prevent
unnecessary damage to the wall.
12 Any variations in pipe length will/may require
adjustment to refrigerant charge.
13 Do not install near a door way.
Outoor Unit
1 Select a site where noise and outflow air
emitted by unit will not annoy neighbors.
2 Select a site where there is sufficient
ventilation.
3 Select a site where there is no obstruction
blocking the inlet and outlet.
4 The site should be able to withstand the full
weight and vibration of the unit.
5 Select a dry place, but do not expose the unit
to direct sunlight or strong wind.
6 Make sure that the outdoor unit is installed in
accordance with the installation instructions,
and is convenient for maintenance and repair.
7 Select a place where it is out of reach of
children and far from animals or plants.
8 Select a place where the unit keeps the
horizontal and aligned position.
9 Select at a place that respects the minimum
distances around the outdoor unit as below:
A proper installation site is vital for correct and
efficient operation of the unit.
Avoid the following sites where:
• strong heat sources, vapour, flammable gas
or volatile liquids are emitted.
• high-frequency electro-magnetic waves are
generated by radio equipment, welders or
medical equipment.
• salt-laden air prevails (such as close to
coastal areas).
• the air is contaminated with industrial vapours
and oils.
• the air contains sulphurous gas such as in hot
spring zones.
• corrosion or poor air quality exists.
indoor Unit
1 The air inlet and outlet should be away from
the obstructions. Ensure the air can be blown
through the whole room.
2 Select a site where the condensing water can
be easily drained out, and where it is easily
connected for the outdoor unit.
3 Select a place where it is out of reach of
children.
4 Select the place where the wall is strong
enough to withstand the full weight and
vibration of the unit.
5 be sure to leave enough space to allow
access for routine maintenance.
For optimum performance, the indoor unit
should be installed on the wall at a height
no less than 2.5 meters above the floor.
6 Make sure that the indoor unit is installed in
accordance with installation dimension as
below: