Electrolux EN3850DOX - Manual (Page 20)

Problem Possible cause Solution
The room temperature is
too high. Decrease the room temper-
ature.
The Fast freezing function
is switched on. Refer to "Fast freezing
function"
Water flows on the
rear plate of the re-
frigerator. During the automatic de-
frosting process, frost de-
frosts on the rear plate. This is correct.
Water flows into the
refrigerator. The water outlet is clog-
ged. Clean the water outlet.
Products prevent that wa-
ter flows into the water
collector. Make sure that products do
not touch the rear plate.
Water flows on the
ground. The melting water outlet
does not flow in the evap-
orative tray above the
compressor. Attach the melting water
outlet to the evaporative
tray.
There is too much
frost and ice. Products are not wrapped
properly. Wrap the products better.
The door is not closed
correctly. Refer to "Closing the door".
The Temperature regulator
may be set incorrectly. Set a higher temperature.
The temperature in
the appliance is too
high. The door is not closed
correctly. Refer to "Closing the door".
The product temperature
is too high. Let the product tempera-
ture decrease to room tem-
perature before storage.
Many products are stored
at the same time. Store less products at the
same time.
The temperature in
the refrigeration is
too high. There is no cold air circu-
lation in the appliance. Make sure that there is cold
air circulation in the appli-
ance.
The temperature in
the freezer is too
high. Products are too near to
each other. Store products so that
there is cold air circulation.
The appliance does
not operate. The appliance is switched
off. Switch on the appliance.
The mains plug is not con-
nected to the mains sock-
et correctly. Connect the mains plug to
the mains socket correctly.
20 www.electrolux.com