1 drying setting, 2 drying at automatic levels, 3 timed drying – Electrolux EWW1486HDW User Manual

Page 19: 4 end of the drying programme

Advertising
background image

11.1 Drying setting

WARNING!

Open the water tap. Put the drain

hose in the sink or connect to the

drain pipe.
1. Press On/Off for some seconds to

activate the appliance.

2. Load the laundry one item at a time.

3. Turn the programme dial to the

programme applicable for the items to

dry. The display shows the drying

indicator

.

To have a good drying

performance

do not exceed

the maximum drying loads

recommended in the user

manual.

Do not set a spin

speed lower than the

automatic speed of the set

programme.

11.2 Drying at automatic levels

The laundry can be dried at pre-defined

levels of dryness:

1. Press again and again until the

display shows one of the dryness level

indicator:

: IRON DRY level indicator for

cotton items

: CUPBOARD DRY level

indicator for cotton and synthetic

items

: EXTRA DRY level indicator for

cotton items

The display shows a time value, calculated

on the default load size. If the amount of

your laundry is more or less than the

default size, the appliance adjusts

automatically the time value during the

cycle.
2. Press

to start the programme.

The display shows the door locked
indicator

. The drying indicator

starts to flash.

You cannot set all dryness

levels for any type of laundry.

11.3 Timed drying

The laundry can also be dried with a

manual timed drying:

1. Press

again and again to set the

time value (see the «Programmes for

timed drying» table).

• The display shows 10 minutes.

Each time you press this touchpad

the time value increases by 5

minutes.

• The display shows the set time

value: for example –

.

• After some seconds the display

shows a new time value:

. The

appliance calculates also the

duration of the anti-crease and the

cooling phases.

2. Press

to start the programme.

• The display shows regularly a new

time value.

• The drying indicator starts to

flash.

• The display shows the door locked

indicator

.

If you set only 10 minutes of drying, the

appliance performs only a cooling phase.
If the laundry is not sufficient dry, set again

a short drying time.

11.4 End of the drying

programme

The appliance stops automatically.
• The acoustic signals operate (if they

are active).

• In the display comes on.
• The indicator

goes off.

• The last minutes of the drying cycle the

appliance performs a cooling and anti-

crease phase. The door is still locked.

When the door locked

goes off in the

display, you can open the door.

1. Press the button for some seconds

to deactivate the appliance.

ENGLISH

19

Advertising