Electrolux EWW1486HDW - Manual (Page 20)

After some minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
2. Remove the laundry from the
appliance.
Make sure that the drum is empty.
3. Keep the door ajar, to prevent mildew
and odours.
4. Close the water tap.
12. DAILY USE - WASHING & DRYING
WARNING!
Refer to Safety chapters.
12.1 Non-Stop programme
1. Press On/Off for some seconds to
activate the appliance.
2. Load the laundry one item at a time.
To have a good drying
performance do not exceed
the maximum drying loads
recommended in the user
manual. Do not set a spin
speed lower than the
automatic speed of the set
programme.
3. Put the detergent and the additives in
the appropriate compartment.
4. Turn the programme dial to the
washing programme.
The display shows the indicators of the
different washing phases.
5. Set the available options.
12.2 Washing & Automatic
drying
1. Press again and again until the
display shows one of the dryness level
indicator:
• : IRON DRY level indicator for
cotton items
• : CUPBOARD DRY level
indicator for cotton and synthetic
items
• : EXTRA DRY level indicator for
cotton items
The display shows the indicator . The
time value on the display is the duration of
the washing + drying cycles, calculated on
a default load size.
To have a good drying the
appliance does not let you set
a too low spin speed for the
items to be washed and dried.
2. Press to start the programme.
In the display the indicator of the set
dryness level stays on.
The door locked indicator
goes on.
The display shows regularly a new time
value.
The last minutes of the drying
cycle the appliance performs
the anti-crease and the cooling
phases.
12.3 Washing & Timed Drying
To have a good drying the appliance does
not let you set a too low spin speed for
the items to be washed and dried.
1. Press to set the drying time value.
The display shows 10 minutes.
The indicator comes on in the display.
The display shows the set drying value
time. for example:
. After some
seconds the display shows the final time
value
, that is the total duration of
the washing and drying cycles (washing +
drying + anti-crease + cooling phases).
If you set only 10 minutes of
drying after washing, the
appliance calculates also the
duration of the anti-crease and
the cooling phases.
2. Press to start the programme.
In the display the indicator comes on.
The door is locked. The display shows
regularly a new time value.
www.electrolux.com 20