Electrolux ENF4451AOX - Manual (Page 32)

Problem Possible cause Solution
Upper or lower
square is shown in
the temperature dis-
play. An error has occurred in
measuring the tempera-
ture. Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
DEMO appears on
the Display. The appliance is in dem-
onstration mode (DEMO). Keep pressed approximate-
ly 10 sec. the Mode button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
6.1 Replacing the lamp
CAUTION!
Disconnect the plug from the mains sock-
et.
1
2
1. Press on the rear hook of the lamp
cover by a screwdriver and at the
same time pull and rotate the cover in
the direction of the arrow.
2. Replace the lamp with one of the
same power and specifically designed
for household appliances. (the maxi-
mum power is shown on the light
bulb cover).
3. Fix the lamp cover into its original po-
sition.
4. Connect the plug to the mains sock-
et.
5. Open the door. Make sure that the
light comes on.
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.
7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance. 7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
32 www.electrolux.com