Anschutz 64 R - Manual (Page 10)

23
•Repeat this process until you do not feel
the second stage anymore. Then turn
1 /
4
turn back to the right. Thus the
optimum sear engagement is adjusted.
The sear engagement is too short:
There is no second stage. The trigger
releases undefined without second stage.
•Turn set screw No. 1 clockwise for at
least 1 /
4
turn after cocking. Then release
the trigger and check if there is a second
stage. If not, repeat this procedure until
you feel a second stage.
•As soon as you feel a second stage
proceed according to the points of the
paragraph „The sear engagement is too
long“ to obtain an optimum sear
engagement.
Adjustment of the optimum sear
engagement for assembled
single stage
triggers with set screw No. 1:
•Cock the rifle.
•Turn set screw No. 1 (first stage) as long
to the right until the trigger releases.
•Turn set screw No. 1 from this position
approx. 1 /
4
turn to the left.
Warning:
Single stage triggers are very sensitive and
must be operated with special care.
The sear engagement of 5 /
100
mm is ob-
tained after the action is closed. In
combination with a minimum trigger weight
there might be a malfunction and an
increased risk (independent shot
release).
3. Malfunctions of the trigger due to
wrong adjustment procedure
If the trigger is not adjusted correctly mal-
functions may occur, tampering with the
trigger adjustments will not result in any
success. Therefore proceed as follows:
After every change the function of the
trigger must be checked. When the
malfunction is removed check the desired
trigger values and adjust them again if
necessary.
The trigger catches the cocking piston or
firing pin, but the trigger does not release:
•Make sure that the safety of the trigger is
released.
The trigger does not catch the cocking
piston or firing pin:
•The first stage trigger is adjusted too
tightly.
•Turn set screw No. 1 approx. 1-2 turns
to the left. Procede according to par. 2.
4. Maintenance
Please see chapter „Cleaning, mainte-
nance, care, oils“.