Anschutz 64 R - Manual (Page 7)

20
Small bore target rifles
Mod. 64 R
Technical Data:
64 R
Caliber:
.22 l.r.
Barrel length: 54 cm/21.2“
Rifling: 54 cm/21.2“
Total length: 100 cm/39.3“
Total lengthSystem: 69 cm/27.2“
Weight approx.:
3,6 kg/7.9 lbs
Version: Repeater
is solely responsible. We also assume no
responsibility for defects resulting from
inappropriate transportation (mail,
forwarding agency, plane, etc.). Please
immediately contact your transporter in
such a case.
3. Changes or alterations to this rifle or any
of its parts are prohibited. Such changes
or alterations can significantly impair the
safe use of our product and can lead to
accidents involving severe or even fatal
bodily injuries. Any product warranty will
automatically lapse in case changes or
alterations are implemented. Users are
requested to carefully inspect the product
with regard to possible changes and
alterations before use. In case of doubt you
should contact us for further information.
Assembly, fitting the
ANSCHÜTZ barreled action
The stock, the barreled action and the bolt
are packed separately for shipment and
need to be assembled. However, do not
do this until you have followed all the
procedures listed below.
•Wipe away excess oil from the barreled
action and the bolt.
•Cock the bolt by turning the guide bolt
and the bolt handle opposite to each other.
•Insert the bolt by actuated trigger.
•Remove the magazine from the
magazine well.
•Insert the barreled action into the barrel
channel in the stock and press both parts
together.
•Screw in bedding screws with suitable
allen wrench. First slightly tighten all
screws. Then tighten the front screws and
subsequently the rear screws (in the
direction of the muzzle). For correct
adjustments we recommend a torque
wrench, which is to be adjusted to
5 Nm (= 50 cmkp) for wood stocks.
•Pull a cleaning patch through the barrel
from the chamber towards the muzzle
several times.
•Push the magazine in the magazine well
until you hear that the magazine holder
caught the magazine.