Bosch B30IB800SP - Manual (Page 13)

13
1. Attaching the anti-tip-brackets
, WARNING:
Risk of injury and damage!
Assure that there are no electrical wires or
plumbing in the area which the screws could
penetrate.
, CAUTION:
Risk of injury!
Always wear safety glasses and other necessary
protective devices or apparel when installing or
working with dowels.
Note:

2 anti-tip-brackets are required for the appliance.

The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
The anti-tip-brackets (a) must overlap a minimum of
2 1 /
8
” (54 mm) over the appliance to secure the
appliance.
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening
a spacer (b) behind the anti-tip angle, e.g. a sufficiently
dimensioned wood board.
The length of the plank should correspond to the width
of the installation niche!
1. Specify the attachment points of the anti-tip-brackets
according to the section on “Installation
dimensions”.
2. Attach the anti-tip-brackets completely.
Be sure screws hold tight.
Important notes for fastening with dowels and screws:
Not recommended for use in light-weight masonry
material such as cinder block.
Not recommended for use in new concrete which has not
had time to cure.