AYRE K-5xe - Manual (Page 10)

Input Source Selection
The input selector buttons are located below the
display. Alpha-numeric labels that match the
connector labels on the rear panel (B1, B2, S1, S2)
are used to denote the inputs. When the unit is first
connected to an AC power source, the “B1” input is
selected by default.
Tape Output
The “Tape Output” function
does not operate on the “S2”
input. This avoids the
undesired possibility of
creating a feedback loop.
When the “Tape Output” button is pressed, the
indicator will light up and the signal from the
currently selected source component will be routed
to the “Tape Out” connectors. This allows a
recording to be made.
Turn the “Tape Output” off, unless a recording is
being made. This will completely disconnect the
recorder from the K-5xe
MP (including the ground
connection), avoiding the possibility of undesired
ground loops.
Additional Functions
The following function is available only via the
remote control handset.
Display
The display of the K-5xe MP may be turned off if
desired. A single blue light indicates that the
8