Apricorn EZ Bus DTS - Manual (Page 9)

www.apricorn.com 9
3. CONNECTING YOUR EZ BUS DTS
You have two choices for setting up your EZ Bus DTS. You may use either the
eSATA to eSATA cable or the USB cable provided:
For use with the eSATA cable on a system with a pre-installed eSATA card:
1. Start by turning off your computer.
3. Connect the eSATA cable to the eSATA port at the rear of the EZ Bus DTS
and the other end to an available port on your pre-installed eSATA card
4. Connect the AC adapter at the rear of the EZ Bus DTS and then plug into
an available wall outlet or power strip.
5. Push the on switch located on the front of the EZ Bus DTS. The indicator
light will come on to let you know that the EZ Bus DTS is powered.
6. Now, power up your computer.
For use with the USB cable:
1. Connect the USB cable to the USB port at the rear of the EZ Bus DTS and
to an available USB Port on your computer.
2. Connect the AC adapter at the rear of the EZ Bus DTS and then plug into
an available wall outlet or power strip.
3. Push the on switch located on the front of the EZ Bus DTS. The indicator
light will come on to let you know that the EZ Bus DTS is powered.